J.P. Instruments EDM 960 Twin Pilots Guide - Manual (Page 46)

For Your Safe Flight Page 41
3. Adjust the value using the PLUS or MINUS until the value equals the
altimeter setting (sea level airport). The adjustment range for the
MAP is ±3.0 inHg.
4. Hold both NEXT and Button 2 until you see SET.
5. Repeat for right engine.
Adjusting the HP Value
You must set the nominal horsepower of your engine. This value is used
to calculate the percent horsepower display.
1. Enter the pilot program mode by simultaneously holding the STEP
and LF buttons for five seconds.
2. Tap NEXT repeatedly until you see Engine HP 200 . Then hold both
the NEXT and Button 2 until you see ADJUST momentarily.
3. Adjust the value PLUS or MINUS to equal your engines HP.
6. Hold both NEXT and Button 2 until you see SET
Fuel Flow K factor
The K factor is shown on the fuel flow transducer as a hand written four-
digit number, which represents the number of pulses per tenth gallon of
fuel flow. Before installing the transducer, record its K factor below.
The EDM stores the K Factor in the form 29.12, i.e. if the transducer K
factor is 2912, you would enter 29.12 in the EDM’s K factor field.
Left engine transducer K factor: ___________ .
Right engine transducer K factor:___________ .
If you have return line flow transducers, record them below:
Left engine return flow transducer K factor: __________ .
Right engine return flow transducer K factor:__________ .