J.P. Instruments EDM 960 Twin Pilots Guide - Manual (Page 23)

For Your Safe Flight Page 18
Manual Mode
To activate Manual Mode, just tap the STEP button. Use Manual
mode to lock on one measurement, such as your hottest CHT. Select
desired parameter by tapping
STEP button. Return to Automatic mode by
tapping LF and then tap STEP . Disable Automatic mode by setting ‘Auto
Scan Rate 0’. See Pilot Programming.
Scan Sequence Example
Measurement Example Comments
EGT, CHT 1340 EGT 1410
376 CHT 421
Square indicates cylinder
TIT, Turbine Inlet
Temperature
1370 TIT 1350
Turbine #1
Shock Cooling CLD
-22 °/Min -23
Square indicates fastest cooling
cylinder
Difference
between hottest
and coldest EGT EGT
30 Span 20
Square indicates most widely deviating
cylinder
Compressor
Discharge
Temperature
300 CDT 295
Into intercooler
Carburetor
Temperature
-22 CRB -20
Not available when CDT is installed
Induction Air
Temperature
125 IAT 120
Out of intercooler
Fuel Remaining Calculated
REM 83.6 GAL
In gallons, liters, pounds or kilograms
Fuel required to
next GPS WPT or
Destination Total
REQ 25.9 GAL
Present with GPS interface valid signal
and way point
Fuel Reserve at
next GPS WPT or
Destination Calculated
RES 11.3 GAL
Present with GPS interface valid signal
and way point
Nautical Miles per
Gal AIRCRAFT
ECON 04.8 MPG
Present with GPS interface and valid
signal or MPK, MPL, MPP
Time to Empty Calculated
ENDUR 02:25
Hours:minutes remaining at current
fuel burn rate.
Total Fuel Flow TOTAL
FF 29.5 GPH
Total fuel burn rate
Fuel Flow Fuel
14.9 GPH 14.6
Individual engine fuel burn rate
Total Fuel Used Total
USED 76.9 GAL
Since last refueling or trip total.