J.P. Instruments EDM 960 Twin Pilots Guide - Manual (Page 17)

For Your Safe Flight Page 12
2 nd Button
• In Automatic or Manual modes, tapping the
LF button will activate
the LeanFind mode.
• In the LF mode holding the
LF button after peak EGT is found will
display the peak EGT.
• In Automatic or Manual modes holding the
LF button for three
seconds will toggle between Standard and Normalize (NRM) views.
• In the programming mode, tapping the
PLUS or MINUS button will
allow you to edit a parameter value.
• Holding
LF during power up will display the primary alarm limits
after the self-test is complete.
1 st and 2 nd Buttons
• Holding both the
STEP and LF buttons simultaneously for five
seconds will enter the pilot programming mode.
• Just after entering Lean Find Mode (but before any EGT has risen),
holding both First and Second buttons for five seconds will toggle
between LOP or ROP leaning modes.
• Tapping both the
STEP and LF buttons simultaneously in Manual
mode toggles to ‘include’ or ‘exclude’ the displayed non-primary
measurement from the Automatic mode. Note: Measurements are
never excluded from the Manual mode.
3
rd
Button
• Tapping
DIM (brightness decreases) or holding DIM (brightness
increases) allows decrease or increase brightness respectively. Hold
on start-up to enter fuel level table
2 nd and 3 rd Buttons
• Holding both the
LF and DIM buttons simultaneously will display the
Hobbs readings. Tap button labeled NEXT to see additional
information screens..
4 th Button ( ALL/EGT/FF )
• Select what is shown during Scanner auto-sequence. Choices are
ALL , EGT or FF . Highlighted one is what is active. Hold on start-up
to enter fuel level readings.