GFB G-Force2 - Manual (Page 12)

Input Setup allows you to configure the purpose of the external input (blue wire). For information on how to
connect the external input to a button or switch, see the wiring diagram on page 3.
There are three modes for the external input:
? OFF - no action
? SCr - the scramble feature is activated when the external input is triggered
? PrE - scrolls sequentially through the boost pressure memories when triggered (in the same way as pressing
the “down” button in running mode)
? From Running Mode, use the “MENU” button to navigate to the Input setting (display scrolls “INPUt”)
? Use the “UP/DOWN” buttons to select from “OFF” (default), SCr, or PrE
? Tap “MENU” to save and move on to the next menu item, or hold “MENU” to save and exit to Running Mode
12 - controller functions
Display allows you to configure the boost gauge display to read boost pressure in kPa (default), BAR or PSI.
Note that when PSI is selected, vacuum is displayed in inHg (inches mercury), which is the same as found on most
psi unit boost gauges.
? From Running Mode, use the “MENU” button to navigate to the Display setting (display scrolls “dISP”)
? Use the “UP/DOWN” buttons to select from “KPA” (default), “BAR” or “PSI”
? Tap “MENU” to save and move on to the next menu item, or hold “MENU” to save and exit to Running Mode
display setting - units of pressure
Display scrolls “dISP”, followed by the current setting (default is “KPA”).
Display
Use the up/down buttons to adjust the value from kPa, BAR, or PSI
To exit
Display scrolls “INPUt”, followed by the current setting (default is “OFF”).
Input
Use the up/down buttons to select from OFF, Scr, or PrE
MENU Hold
To exit
input setup
MENU Hold
Tap MENU
Tap MENU
Tap MENU
Tap MENU
MENU Hold