GFB Short Shift Basic Kit for STi 6 speed transmission (part 4003) - Manual

Instructions for GFB Short Shift Basic Kit for STi 6 speed transmission
Included in kit:
•
1 x gearstick
•
1 x pin remover, including:
2 x M5 slot screws
•
1 x 4mm hex key
•
1 x cable/zip tie
Required tools:
•
2 x 12mm spanner/wrench
•
Medium flat-blade and Phillips screwdriver
•
Side cutters/knife
•
Circlip pliers (or pointy needle-nose pliers
will suffice)
•
Rag
GFB Short Shift Kits carry a lifetime warranty which covers faulty components or manufacturing. Warranty is limited only to the
repair or replacement of GFB products provided they are used as intended and in accordance with all appropriate warnings and
limitations. No other warranty is expressed or implied.
We HIGHLY recommend you read through the instructions and familiarise yourself with the steps
before starting installation of this product.
1. Lift the lid of the centre console between the seats
above the handbrake. On the plastic handbrake shroud
there are two slots, using the flat-blade screwdriver
padded with a rag, carefully lever the shroud up on
each side (there is a pop-type fastener on each side).
2.
Lift the handbrake shroud out (taking care of wiring
still attached), to give you access to the gearstick
surround (figure 2).
3.
Unscrew the gear knob and unclip the button fastener
on the leather shift boot. Gently lift the plastic
gearstick shroud up from the back, it is only lightly clipped in and does not need much force.