GFB STi 6 speed short shift kit upgrade (part 4202) - Manual

Instructions for GFB STi 6 speed short shift kit upgrade (part # 4202)
This kit is intended for use only in conjunction with GFB’s STi 6-speed basic shift kit (part # 4003), which
is assumed to have already been installed before fitting this upgrade kit.
This 4202 upgrade kit allows your existing GFB 4003 shifter to be adjusted to even shorter throw settings
than is possible with the 4003 kit alone, and these two kits combined.
Included in kit:
•
2 x side plates
•
1 x linkage knuckle, including:
2 x M4 x 12 socket screws
•
2 x M8 washers
•
2 x M8 x 16 button head screws & nuts
•
2 x M5 x 8 button head screws
•
1 x 3mm hex key
•
1 x 5mm hex key
Required tools:
•
2 x 12mm spanner/wrench
•
Medium flat-blade and phillips screwdriver
We HIGHLY recommend you read through the instructions and familiarise yourself with the steps
before starting installation of this product.
1. Lift the lid of the centre console between the seats above the
handbrake. On the plastic handbrake shroud there are two
slots, using the flat-blade screwdriver padded with a rag,
carefully lever the shroud up on each side (there is a pop-
type fastener on each side).
2.
Lift the handbrake shroud out (taking care of wiring still
attached), to give you access to the gearstick surround
(figure 2).
3.
Unscrew the gear knob and unclip the button fastener on the
leather shift boot. Gently lift the plastic gearstick shroud up
from the back, it is only lightly clipped in and does not need
much force.