beautypg.com

Hornady Lock-N-Load Powder Measure with Case-Activated Powder Drop User Manual

Page 17

background image

- 16 -

Step 6: Case Activated Powder Drop Adjustments

Insert a case into the shell plate at station 3 of your Lock-N-Load AP and operate

the handle to raise the ram to its highest position. (refer to pg. 13 in your Lock-N-
Load AP manual)

Lower the Powder Measure by rotating it Clock-Wise (CW) into the press until the

Powder Measure Rotor is fully rotated, but not contacting the end of the slot in the
Powder Measure Body.

Lower the Ram and attach the Return Spring (#14) between the two Spring Pins (#13).

Check the adjustment for correct positioning and secure the adjustment with the

lock ring.

Clean the Case Activated Powder Drop at the end of each reloading session with a
clean dry cloth to prevent a build up of excess powder. This helps prevent the inter-
nal sleeve from sticking and spilling powder around the cartridge cases as they are
loaded.

Fig. 5: Final Powder
Measure Assembly.