Hornady Lock-N-Load Light Strip - Manual

Lock-N-Load ® Light Strip
Mounting Instructions
1.) The Hornady ® Lock-N-Load ® Light Strip
can be mounted to most smooth, clean
surfaces. Before mounting, place light strip
in desired location to check fit and operation
of press, as well as cord length. To prevent
damage to the light and cord, no moving part of
the press or equipment should come in contact
with the light or cord.
2.) To mount light, clean surface where light
strip is to be mounted with a non-residue
forming cleaner such as rubbing alcohol or
similar cleaner. Cleaning solution should be
tested with surface to ensure it will not harm
surface.
3.) Remove paper backing and firmly press one
end of light strip onto surface. While moving
down the light, firmly press light against
surface to ensure proper adhesion.
4.) Route the light cord around the press
avoiding moving components. On the Hornady ®
Lock-N-Load ® AP Press, the cord will fit under
the catch bin bracket on the left side of
the press.
5.) Plug light into supplied power supply.