Hyline Offroad TJ/YJ CRAWLER FRONT BUMPER - Manual (Page 3)

Step 4 – Install proper Bumper Mounting Brackets (See Figure 2) using four (4)
Supplied ½” Bolts, Lock Washers, and Flat Washers. Brackets are
Located with the vertical flanges toward outside of frame rails.
DO NOT TIGHTEN BOLTS YET
Step 5 – Measure from center point (measured in Step 3) to outside of the
Vertical flange on bracket. Locate bracket at 16 7/8 ” from center point.
Repeat to opposite side bracket. (See Figure 3) This step will ensure
The bumper slides over the brackets easily. Once brackets are in proper
position Torque all four (4) bolts to 119 ft./lbs.
T:\Hyline Offroad, LLC\Installation Instructions\TJ-YJ-10SFB\TJ-YJ-10SFB Installation Instructions.doc
Page 3 of 5
REV 1 11/04/08
You may at this point install winch with bumper off vehicle OR you can wait until
after bumper is mounted on the vehicle. We recommend installing the winch after
mounting the bumper so you’re not lifting so much weight.
YJ
1987-1995
TJ
1997-2006