Hyline Offroad JK SERIES STANDARD REAR TIRE CARRIER User Manual

Proudly made in, Parts list, Tools needed

T:\Hyline Offroad, LLC\Installation Instructions\JK-21STC\JK-21STC Installation Instructions.doc

Page 1 of 4

REV 3 1/9/2012

Proudly Made In

USA

Installation Instructions:
JK Gen II Swingout Tire Carrier
Part Number: JK-21STC

Vehicle Fitment:
2007-Present Jeep Wrangler &
Unlimited

Parts List

Qty:

1 Swingout Tire Carrier
1 Slide Adjustable Tire Mount
1 Black Tailgate Bracket Plate
1 Machined Pivot Pin
1 Machined White Plastic Alignment Block
2 Brass Washers for Pivot Pin
4 ½”-13 x 1-1/2 Gr. 8 Hex Head Bolts
1 ½”-13 x 1” Gr. 8 Hex Head Bolt
5 ½” Lock Washers Gr. 8
5 ½” Flat Washers Gr. 8
2 5/16”-18 x 1-3/4” Gr. 5 Hex Head Bolts
4 5/16” Flat Washers Gr. 5
2 5/16”-18 Nylok Hex Nut Gr. 5
2 3/8” Flat Washers Gr. 5
2 3/8”-24 Nylok Hex Nut Gr. 5
1 3/8”-24 RH Thread Thin Hex Nut Gr. 5
1 3/8”-24 LH Thread Thin Hex Nut Gr. 5
1 Right Hand Thread Ball Joint Rod End
1 Left Hand Thread Ball Joint Rod End

1 Aluminum Connector Rod

3 Wheel Studs
1 1/8” PTF Stainless Steel Grease Fitting

Tools Needed

5 lb. Hammer

Or Heavy Duty Vise

Congratulations on your purchase of the Hyline Offroad Gen II Swingout Tire
Carrier. Our Products are completely manufactured in our facility located in
Perkasie, PA. They are designed and engineered by Offroad enthusiasts just like
you to be rock solid at an affordable price. Hyline Offroad would like to thank
you for your recent purchase and look forward to serving you in the future.

Hyline Offroad Staff

13mm Socket

¾” Socket
½” Socket

9/16” Socket

T20 Torx Bit

Grease Gun

Lithium Grease

½” Wrench
¾” Wrench

7/16” Wrench

Wire Cutters