If applicable – Hyline Offroad TJ/YJ CRAWLER FRONT BUMPER User Manual
Page 2
***IMPORTANT***
Unlike many other designs, Our ORIGINAL design allows you to install your winch AFTER installing
the bumper. So if you wanted to add a winch down the road our design allows you to do so without
removing your bumper. To install your winch after mounting the bumper follow the insturctions
starting on Page 4.
Front Bumper Installation
Step 1 – Remove Stock bumper by unbolting the six (6) T-55 Torx Bolts.
Two on the top of each side of the bumper and one on the
Bottom of each side. Say goodbye to that flimsy stock bumper.
Step 2 – Remove plastic factory sway bar cover by unbolting four (4) 3/8”
Bolts from each side of cover. Do Not Throw This Cover Away.
Step 3 – Using tape measure, find the center point in between frame rails by
Measuring the total width from inside frame rails. Mark the center
Point. (See Figure 1)
T:\Hyline Offroad, LLC\Installation Instructions\TJ-YJ-10SFB\TJ-YJ-10SFB Installation Instructions.doc
Page 2 of 5
REV 1 11/04/08
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
Figure 1
If Applicable
Disconnect all External Lighting
Wiring that is presently attached
to existing bumper.