Bosch 24iw50nsp - Manual (Page 17)

17
Required accessories and tools
1. Supplied accessories
- Installation instructions
- Operating instructions
- Installation kit
2. Optional accessories 8.
Basic Combination SideĆbyĆSide Sealing kit
For permanent connection of two individual appliances,
e. g. Freezer next to Refrigerator.
Extreme Combination SideĆbyĆSide Heating kit
If the gap between the appliances is less than
6" (160 mm).
Extra long finger protection part
Panel unification part (Metal strip)
For connection of two furniture doors.
Can be used
for standard height furniture doors without further
preliminary work.
3. Other required accessories
from specialist outlets
Ice maker installation kit ¼" OD copper line
For connecting appliances which require water, e.g. for
an ice maker.
i Maximum outer diameter of the water pipe
(without fittings):
13 /
32
" (10 mm).
4. Tools
- Cordless screwdriver T20
- Torx screwdriver T20
- Torx bit T20 + magnetic holder
- 5 /
16
" (8 mm) hex nut driver
- Wood drills in different sizes
- Open end wrench ½" (SW 13 mm)
- Multigrip pliers
- Adjustable wrench
- Cutter with adjustable blade
- Metal tape measure
- Square
- Spirit level length 2' (60 cm) and 4' (1,2 m)
- MarkingĆout level, length at least 4' (1.2 m) for
individual appliances or 7' (2.0 m) for SideĆbyĆSide
installation
5. Other
- Stepladder
- Dolly, hand truck
- Hammer drill for drilling holes in wall or floor
- Bits according suitable for material and in different
sizes
- Wooden beam (cross section min. 3" x 4") as an
alternative tilt protection, length according to the
width of the installation cavity
- Wooden screws in different sizes
- Thin (max. 1/16" (1.5 mm)), suitable material to
protect the floor from damage (e.g. lino)
- Suitable material for covering and protecting
furniture (e.g. protective sheets)
- Adhesive tape