Park brake, Parking procedure, Park brake -7 parking procedure -7 – SkyTrak 6036 Operation Manual User Manual
Page 45: Warning

Section 3 - Controls and Indicators
3-7
31200749
Park Brake
Park brake switch controls the application and release of the park brake. Indicator
on switch illuminates to indicate brake is applied.
• With the engine running and the park brake switch in "OFF" position (1), park
brakes are disengaged.
• With switch in "ON" position (2), park brake is engaged and transmission will not
engage forward or reverse.
• (6042, 8042, 10042 & 10054 Only) With switch in “ON” position and boom angles
greater than 40°, locked mode of Stabil-Trak system is activated. See page 3-16.
Parking Procedure
1. Using service brake, stop telehandler in an appropriate parking area.
2. Follow “Shut-Down Procedure” on page 4-3.
WARNING
MACHINE ROLL-AWAY HAZARD. Always move park brake switch to "ON"
position, lower boom to ground and stop engine before leaving cab.
WARNING
CRUSH HAZARD. Turning engine off applies the park brake. Applying park
brake or turning engine off while traveling will cause unit to stop abruptly and
could cause load loss. Either may be used in an emergency situation.
OH3821
1
2