ARB 3415010 - Manual (Page 2)

Last Rev Date:29/10/2008 Page 2 of 20 Fitting instructions# 3783250
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
GENERAL CARE AND MAINTENANCE
By choosing an ARB Bar, you have bought a product that is one of the most sought after 4WD products in
the world. Your bar is a properly engineered, reliable, quality accessory that represents excellent value.
To keep your bar in original condition it is important to care and maintain it following these
recommendations:
Prior to exposure to the weather your bar should be treated to a Canuba based polish on all exposed
surfaces. It is recommended that this is performed on a six monthly basis or following exposure to
salt, mud, sand or other contaminants.
As part of any Pre Trip Preparation, or on an annual basis, it is recommended that a thorough visual
inspection of the bar is carried out, making sure that all bolts and other components are torqued to the
correct specification. Also check that all wiring sheaths, connectors, and fittings are free of damage.
Replace any components as necessary. This service can be performed by your local authorised ARB
Stockist.
FITTING REQUIREMENTS
REQUIRED TOOLS FOR FITMENT OF PRODUCT:
Metric socket and spanner sets 8-25mm range External Circlip pliers
Screwdrivers, Philips and Flat blade Dia 22.0 (7/8”) holesaw
Power Drill 13mm (1/2”) capacity Dia 7.0mm (5/16”) and 10.0mm (25/64”) drill bits
Hacksaw Scriber Centre punch
Files, round, square and flat Hammer 300mm Rule
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT :
Protective eyewear Hearing protection
NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a
potentially hazardous situation it is suggested that protective safety gear be worn or a safe work
procedure be employed. If these notes and warnings are not heeded, injury may result.
FASTENER TORQUE SETTINGS:
SIZE Torque Nm Torque lbft
M6 9Nm 7lbft
M8 22Nm 16lbft
M10 44Nm 32lbft
M12 77Nm 57lbft
OPTIONAL LIGHT SETS TO SUIT THIS PRODUCT:
♦ ARB P#9249FCK 100mm 55WATT FOG LAMP KIT
♦ Up to IPF 900 SERIES FOG OR DRIVING LIGHT SETS
♦ IPF 840 FYS FOG LIGHTS CAN BE FITTED TO LOWER PAN AREA
FOR IPF OPTIONAL FOG LAMPS, ORDER SUPPLEMENTARY KIT# 9381FCK.
IF REFITTING OE FOG LAMPS, ADAPTER BRACKETS ARE SUPPLIED STANDARD WITH THIS
BULL BAR FITTING KIT TO MOUNT THESE LAMPS.
PARTS LISTING