Class1 Total System Manager - Manual (Page 8)

FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473
OPERATION MANUAL
PAGE 7 of 18
DATE 03/01/2013
PRODUCT GROUP System Manager P/N 610-00015 REV 1.01
PRODUCT Total System Manager BY GMC
DATASHEET P/N:FSG-MNL-00103 - UNCONTROLLED IN PRINTED FORMAT - P RINTED : 4/2/14
3.15. Override.
When the Override switch is activated Outputs 1 through 12 will turn on no matter what state they currently operating
in. The Override LED will flash at a 500mS rate to indicate that the Override feature has been activated. Caution
should be paid attention to the Override feature is intended for quickly turning on all Output loads in time of need. If
used to verify that the outputs work in a trouble shooting capacity if the corresponding output LED is turned on and
the load attached to the output does not turn on check for a short or proper output polarity.
3.16. CAN.
The unit transmits the output states and input states VIA CAN (Control Area Network) utilizing the SAE J1939
proprietary, 250 Kbits/second protocol. See section 9 for more information.
4. Programming
4.1. Program Menu.
Programming the Total System Manager is accomplished using push button switches and a straightforward menu
approach. A digital display and 4 LED's provide feedback to the programmer.
4.2. Program Switch.
The program switch has three modes.
Mode 1:
If you press and hold the USER switch and then press the PROG switch this will place the unit into program mode
indicated by displaying 3 dashes (---) on the digital display and the displaying L01.
Mode 2:
If you press and hold the USER switch and then press the PROG switch. Continue to hold the PROG switch for
(aprox. 10 seconds) will load the factory defaults. Indicated by displaying dEF on the digital display.
Mode 3:
When the unit is in program mode holding the PROG switch will save the new values. Indicated by displaying Pro on
the digital display.