Class1 Total System Manager - Manual (Page 13)

FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473
OPERATION MANUAL
PAGE 12 of 18
DATE 03/01/2013
PRODUCT GROUP System Manager P/N 610-00015 REV 1.01
PRODUCT Total System Manager BY GMC
DATASHEET P/N:FSG-MNL-00103 - UNCONTROLLED IN PRINTED FORMAT - P RINTED : 4/2/14
8. Legacy Settings
8.1. History.
The Total System Manager historically was shipped under different part numbers. 101490, 101540, and 101750. The
101490 had positive outputs for loads 1-12 and the 101540 and 101750 had negative outputs for loads 1-12. If
replacing either of these part number use the following setup configurations.
8.2. 101490.
Two configure the unit to work as the 101490 use the following configuration.

Set the Input polarity shunts to the negative position.

Set the Output polarity switch 1-12 to the positive position.

Set the Output polarity switch A (Low voltage alarm) to the negative position.

Set the Output polarity switch I (Auxiliary Voltage alarm) to the positive position.

Set the Output polarity switch V (Variable Trip) to the positive position.

Set the Output polarity switch HI (High Idle) to the positive position.

Set the system voltage to 12 volts (see section 4.10).
8.3. 101540.
Two configure the unit to work as the 101540 use the following configuration.

Set the Input polarity shunts to the negative position.

Set the Output polarity switch 1-12 to the negative position.

Set the Output polarity switch A (Low voltage alarm) to the negative position.

Set the Output polarity switch I (Auxiliary Voltage alarm) to the positive position.

Set the Output polarity switch V (Variable Trip) to the positive position.

Set the Output polarity switch HI (High Idle) to the positive position.

Set the system voltage to 12 volts (see section 4.10).
8.4. 101750.
Two configure the unit to work as the 101750 use the following configuration.

Set the Input polarity shunts to the negative position.

Set the Output polarity switch 1-12 to the negative position.

Set the Output polarity switch A (Low voltage alarm) to the negative position.

Set the Output polarity switch I (Auxiliary Voltage alarm) to the positive position.

Set the Output polarity switch V (Variable Trip) to the positive position.

Set the Output polarity switch HI (High Idle) to the positive position.

Set the system voltage to 24 volts (see section 4.10).