E. autolube® service (qmax/qtwo) – Hale MG User Manual

Page 77

Text mode
Original mode

Muscle Pumps

5-13

E. AutoLube® Service (Qmax/Qtwo)

1. Park the vehicle on a level surface. Shut

down the engine. Set the parking brake
and chock the front and rear wheels.

2. Drain water from the pump.

3. Remove the fill and drain plugs from the

AutoLube® reservoir and drain oil.

4. Use a center punch to mark the

AutoLube® cover and the front bearing
cover housing (for proper alignment
during assembly).

DO NOT USE A CHISEL TO SEPARATE THE
AUTOLUBE® FROM THE PUMP BODY
BECAUSE THE MATING SURFACES MAY BE
SCRATCHED OR GOUGED, WHICH COULD
RESULT IN A LEAK. ALSO, THE AUTOLUBE®
IS MANUFACTURED FROM CAST METAL,
BODY, PRY BETWEEN THE AUTOLUBE®
AND THE PUMP BODY OR AT THE AND IF IT
BECOMES NECESSARY TO PRY THE
AUTOLUBE® APART FROM THE PUMP
AUTOLUBE® “NOTCHES’

5. Remove the cap screws attaching the

AutoLube®, figure 5-6, to the pump body
and gently pry AutoLube® from the pump
body and impeller shaft.