Hale 2CBP - Manual (Page 45)

Maintenance and Repair
Booster Pumps
Sec V- 9
shaft into the gearbox housing bore.
6. Install the retaining ring to hold the bearing
and drive shaft in place.
7. Install a new oil seal.
8. Lift the gearbox onto its base. Apply Loctite
242 and install the 1/2-13 UNC set screw in
the drive shaft until it is flush with the gear-
box housing.
9. Set the gearbox flat with the drive shaft
facing down.
10. Insert the 306W bearing in the bore on the
pump end of the gearbox housing.
11. Insert the pump gear key into the pump
shaft and install the pump gear onto the
shaft. Align the keyway of the pump gear
with the shaft key.
12. Align the pump gear to the drive gear and
install into the gearbox. Press the shaft into
the 306W bearing.
13. Install the 208M bearing over pump shaft.
14. Stand the gearbox housing on its base and
install the gasket and bearing cover. Secure
with 7/16-14 UNC x 1" inch long capscrews.
Torque to 40ft-lbs (54Nm).
15. If the pump is equipped with a cooler, turn
the gearbox over and install the gasket and
water manifold.
If the pump is not equipped with a cooler,
install the gearbox cover.
16. Secure in place using 5/16-18 UNC screws
and lockwashers. See Table 5-2 for proper
torque.
17. Using Loctite™ PST or equal thread-sealing
compound, install the bushings and elbows
in the water manifold.
18. Reinstall the pump onto the apparatus and
check for leaks.