BEA Eagle 10 - Manual (Page 3)

75.5185.04 20070727 Page 3 of 8
3
Mechanical Installation
Opening the sensor
‰ From behind, before installation ‰ From the front, after installation
Mounting the sensor
‰ Paste the template at desired
location.
‰ Insert screws but do not screw
them fully in.
‰ Optional cable routing:
Notch the cover as shown in
the picture.
‰ Drill as instructed. ‰ Pass the cable where
indicated.
4
Electrical Installation
Terminal Connection
1 (Red) 12 to 24 VAC / DC (+)
2 (Black) 12 to 24 VAC / DC (-)
3 (White) Relay Common
4 (Green) Relay N.O.
5 Relay N.C.
Note: Input power tolerance is +/- 10% for
AC, and -10% to +30% for DC power.
‰ Run the cable through the wire
passage hole just below PCB.
‰ Position the sensor and tighten the
two screws. Make sure you leave
enough cable to reach the terminal
block near the top of the sensor.
‰ Wiring connections are as shown above.
or