Brother NX 600 - Manual (Page 152)

APPENDIX
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
146
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
Error messages
If the start/stop button is pressed before the sewing machine is correctly set up or if an operation is performed
incorrectly, an error message appears in the LCD. Follow the instructions that appear. If you press
(OK key),
(Back key) or do the operation correctly while the error message is displayed, the message disappears.
Error Message Probable Cause
The motor locked up because the thread is tangled.
The start/stop button, reverse/reinforcement stitch button or thread
cutter button was pressed while the presser foot was raised.
The reverse/reinforcement stitch button, needle position button or
thread cutter button was pressed while the bobbin winder shaft is
moved to the right.
The start/stop button was pressed while the foot controller was
connected.
A stitch other than the buttonhole, bar tack or darning stitch was
selected and the start/stop button was pressed while the buttonhole
lever is lowered.
The buttonhole, bar tack or darning stitch was selected and the start/
stop button was pressed while the buttonhole lever is raised.
The start/stop button or reverse/reinforcement stitch button was pressed
after a stitch has been deleted.
A pattern is being stored.
The bobbin winder is winding the bobbin.
More than 71 patterns are being combined.
The start/stop button was pressed without connecting the foot controller
while the setting for adjusting the stitch width using the sewing speed
controller is set to [ON].
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
The first pattern was selected while two or more patterns are combined.
The selected setting cannot be changed with the selected pattern.