Bryant DURAPACK 558F - Manual (Page 70)

Copyright 2005 Bryant Heating & Cooling Systems Printed in U.S.A. CL-1 CATALOG NO. 04-53558002-01
CUT
A
L
O
N
G
DO
TTE
D LI
NE
C
U
T
A
L
ONG DO
TT
ED
L
INE
START-UP CHECKLIST
(Remove and Store in Job File)
I. PRELIMINARY INFORMATION
MODEL NO.: _______________________________________
DATE: _____________________________________________
SERIAL NO. _______________________________________
TECHNICIAN: _________________________________________
BUILDING LOCATION: ________________________________
II. PRE-START-UP (insert checkmark in box as each item is completed)
REMOVE COMPRESSOR TIEDOWN BANDS (SIZES 103,121,150,151 ONLY) PER INSTALLATION INSTRUCTIONS
VERIFY THAT CONDENSATE CONNECTION IS INSTALLED AS SHOWN IN THE INSTALLATION
INSTRUCTIONS
CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS
CHECK THAT INDOOR AIR FILTERS ARE CLEAN AND IN PLACE
VERIFY THAT UNIT INSTALLATION IS LEVEL WITHIN TOLERANCES LISTED IN THE
INSTALLATION INSTRUCTIONS
CHECK FAN WHEEL AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS
CHECK PULLEY ALIGNMENT AND BELT TENSION; REFER TO INSTALLATION INSTRUCTIONS
VERIFY INSTALLATION OF ECONOMI$ER IV HOOD (IF EQUIPPED)
III. START-UP
ELECTRICAL
TEMPERATURES
BOTH CIRCUITS OPERATING
REFRIGERANT
VERIFY REFRIGERANT CHARGE USING COOLING CHARGING CHARTS ON PAGES 58-61
(COOLING MODE ONLY)
VERIFY 3-PHASE SCROLL COMPRESSOR IS ROTATING IN THE CORRECT DIRECTION
GENERAL
VERIFY ECONOMI$ER IV MINIMUM VENT POSITION AND CHANGEOVER SETTINGS ARE CONFIGURED
TO JOB REQUIREMENTS (IF EQUIPPED)
SUPPLY VOLTAGE L1-L2 L2-L3 L3-L1
CIRCUIT NO. 1 COMPRESSOR AMPS L1 L2 L3
CIRCUIT NO. 2 COMPRESSOR AMPS L1 L2 L3
INDOOR FAN AMPS L1 L2 L3
OUTDOOR-AIR TEMPERATURE DB
RETURN-AIR TEMPERATURE DB WB
COOLING SUPPLY AIR DB WB
CIRCUIT NO. 1 CIRCUIT NO. 2
REFRIGERANT SUCTION PSIG PSIG
REFRIGERANT TEMPERATURE SUCTION F F
REFRIGERANT LIQUID LINE PSIG PSIG
REFRIGERANT TEMPERATURE LIQUID LINE F F