Vitek VT-3480 GY - Manual (Page 14)

ENGLISH
• For recording, use only normal tapes. Do
not use metal or CrO tapes.
Erase-prevention tabs of cassette tapes
• When recording on a cassette tape, make
sure that the erase prevention tabs are not
removed. Cassettes have removable tabs
that prevent accidental recording or erasing
• To protect the recorded sound,
remove the tab after recording. Cover
the tab hole with adhesive tape to
record on the tape without the tab.
Recording from the radio
. Set the FUNCTION switch to RADIO.
2. Set the BAND SELECTOR switch to FM or
MW.
3. Tune in to the station to be recorded.
. Load a blank cassette into the cassette
compartment with the side to be recorded
on facing up.
5. Press the “PAUSE II” button.
6. Press the “RECORD” button.
Press the “STOP/EJECT” button to stop
recording.
7. Press the PAUSE II button again to continue
recording.
Note
Play and record buttons will be automatically re-
leased when the end of tape has been reached.
Beat cancel switch
If a whistling noise occurs when recording from an
FM or AM station, set the BEAT CANCEL switch to
or 2, whichever gives the best reception.
Advanced Feature
Recording from Cd/USB
. Set the FUNCTION switch to CD or USB.
2. Load a blank cassette into the cassette
compartment with the side to be recorded
on facing up.
3. Press the RECORD button, the recording will
begin.
. When press the STOP/EJECT / button
during recording, the record indicator will
disappear, but CD will be still spinning.
5. To stop the CD spinning press the “”
button.
Programmed track recording from Cd/USB
. Select the memories track you want to
record.
2. After memories the selected track, press the
RECORD button. The recording for memory
track will begin until end.
3. When press the STOP/EJECT / button
during recording, the record indicator will
disappear, but CD will be still spinning.
. To stop the CD spinning press the “”
button.
Note
Cassette play and record buttons will automati-
cally release when the end of tape has been
reached.
Enhancing your system
Headphone
• Before plugging in the headphones, make
sure the volume level is reduced.
• Be sure your headphones have a 3.5 mm
diameter plug and are between 6 ohms and
50 ohms impedance. The recommended
impedance is 32 ohms.
• When headphones are connected, the
speakers are disconnected automatically.
Adjust the VOLUME control for desired
volume.
References
Troubleshooting chart
Many potential problems can be resolved by
the owner without calling a service technician. If
something is wrong with this product, check the
following before calling your authorized VITEK
dealer or service centre.
3480.indd 14 23.04.2007 16:03:01