beautypg.com

Important safety instructions, Save these instructions, Warning – Briggs & Stratton NEMA 3R User Manual

Page 4: Notice

background image

4

BRIGGSandSTRATTON.COM

Important Safety Instructions

This is the safety alert symbol. It is used to alert

you to potential personal injury hazards. Obey all

safety messages that follow this symbol to avoid

possible injury or death.

The safety alert symbol ( ) is used with a signal word

(DANGER, CAUTION, WARNING), a pictorial and/or a safety

message to alert you to hazards. DANGER indicates a hazard

which, if not avoided,

will result in death or serious injury.

WARNING indicates a hazard which, if not avoided, could

result in death or serious injury. CAUTION indicates a hazard

which, if not avoided,

might result in minor or moderate

injury. NOTICE indicates a situation that could result in

equipment damage. Follow safety messages to avoid or

reduce the risk of injury or death.
The manufacturer cannot possibly anticipate every possible

circumstance that might involve a hazard. The warnings in

this manual, and the tags and decals affixed to the unit are,

therefore, not all-inclusive. If you use a procedure, work

method or operating technique that the manufacturer does

not specifically recommend, you must satisfy yourself that

it is safe for you and others. You must also make sure that

the procedure, work method or operating technique that you

choose does not render the transfer switch unsafe.

WARNING

Only qualified electricians should attempt installation of

this system, which must strictly comply with applicable

codes, standards and regulations.

WARNING

Low voltage wire cannot be installed in same

conduit as power voltage wiring.

Failure to follow above warning could cause personal

injury, damage and/or malfunction of equipment.

WARNING

Failure to properly ground transfer switch can

result in electrocution.

DO NOT touch bare wires or receptacles.
DO NOT use transfer switch with worn, frayed, bare or

otherwise damaged wiring.
DO NOT handle electrical cords while standing in water,

while barefoot, or while hands or feet are wet.
If you must work around a unit while it is operating,

stand on an insulated dry surface to reduce shock

hazard.
DO NOT allow unqualified persons or children to operate

or service transfer switch.
In case of an accident caused by electrical shock,

immediately shut down the source of electrical power

and contact local authorities. Avoid direct contact with

the victim..


WARNING

Transfer Switch contains hazardous voltage

that can cause personal injury or death.

Despite the safe design of the transfer switch, operating

this equipment imprudently, neglecting its maintenance

or being careless can cause possible injury or death.

NOTICE

Improper treatment of transfer switch can damage it and

shorten its life.

Use transfer switch only for intended uses.
If you have questions about intended use, ask dealer or

contact Briggs and Stratton Power Products.
DO NOT expose transfer switch to excessive moisture,

dust, dirt, or corrosive vapors.
Remain alert at all times while working on this

equipment. NEVER work on the equipment when you are

physically or mentally fatigued.
If connected devices overheat, turn them off and turn off

their circuit breaker/fuse.


Save These Instructions