Brother DCP-750CW - Manual (Page 47)

For Network Users
45
How to set the machine’s
network settings to wireless
LAN or wired LAN
To connect your Brother machine to a wireless or
wired network you must configure the machine from
the machine’s control panel for the network type you
are using.
For wireless LAN
On your machine, press Menu.
Press a or b to choose LAN and press OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose WLAN and press OK.
The wired network interface will become inactive with
this setting.
Press Stop/Exit.
It will take about a minute for the LAN menu on the
LCD to become available again.
For wired LAN
On your machine, press Menu.
Press a or b to choose LAN and press OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose Wired LAN and press OK.
The wireless network interface will become inactive
with this setting.
Press Stop/Exit.
Restoring the network
settings to factory default
To restore all network settings of the internal
Print/Scan server to factory default, please follow the
steps below.
1
Make sure the machine is not operating, then
disconnect all the cables from the machine
(except power cable).
2
Press Menu.
3
Press a or b to choose LAN.
Press OK.
4
Press a or b to choose Factory Reset.
Press OK.
5
Press to select
Yes
.
6
Press to select
Yes
.
7
The machine will restart, re-connect cables
once this is complete.