B&B Electronics Celeron M Universal Network Controller with PC/104 Extension UNO-2170 - Manual (Page 24)

Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
The procedure for installing a CompactFlash™ card into the UNO-2170
is detailed below, please follow these steps carefully.
1. Remove the power cord.
2. Unscrew the four screws from the rear panel of the UNO-2170.
3. Remove the rear panel.
4. Plug a CompactFlash™ card with your OS and application program
into a CompactFlash™ card slot on board.
5. Screw back the rear panel with four screws.
Note The CompactFlash™ slot is allocated as“Secondary IDE Master＂
3.2 Chassis Grounding
The aluminum made UNO-2170 provides good EMI protection and a stable
grounding base. There is an easy-to-connect chassis grounding point for
you to use.
Please connect chassis ground of UNO-2170 with "EARTH" as ground.
Figure 3.1: Chassis Grounding Connection
UNO-2170 User Manual 18