B&B Electronics Celeron M Universal Network Controller with PC/104 Extension UNO-2170 - Manual (Page 19)

2.4 LAN: Ethernet Connector
The UNO-2170 is equipped with a Realtek RTL8139C Ethernet LAN
controller that is fully compliant with IEEE 802.3u 10/100Base-T
CSMA/CD standards. The Ethernet port provides a standard RJ-45 jack
on board, and LED indicators on the front side to show its Link (Green
LED) and Active (Yellow LED) status.
2.5 Power Connector
The UNO-2170 comes with a Phoenix connector that carries 9~36 VDC
external power input, and features reversed wiring protection. Therefore, it
will not cause any damage to the system by reversed wiring of ground line
and power line. Please refer to Appendix A.6
2.6 PS/2 Keyboard and Mouse Connector
The UNO-2170 provides a PS/2 keyboard and PS/2 mouse connector. A
6-pin mini-DIN connector is located on the rear panel of the UNO-2170.
The UNO-2170 comes with an adapter to convert from the 6-pin mini- DIN
connector to two 6-pin mini-DIN connectors for PS/2 keyboard and PS/2
mouse connection. Please refer to Appendix A.7 for its pin assignments.
2.7 USB Connector
The USB connector is used for connecting any device that conforms to the
USB interface. Many recent digital devices conform to this standard. The
USB interface supports Plug and Play, which enables you to connect or
disconnect a device whenever you want, without turning off the computer.
The UNO-2170 provides two connectors of USB interfaces, which gives
complete Plug & Play and hot swapping for up to 127 external devices.
The USB interface complies with USB UHCI, Rev. 2.0 compliant. The
USB interface can be disabled in the system BIOS setup. Please refer to
Appendix A.8 for its pin assignments.
13 Chapter 2