Brother VERSION 0 MFC-J6510DW - Manual (Page 79)

Routine maintenance
73
A
Packing and shipping
the machine
A
When you transport the machine, use the
packing materials that came with your
machine. If you do not pack the machine
properly, any damage that may occur in
transit may not be covered by your warranty.
IMPORTANT
It is important to allow the machine to
“park” the print head after a print job.
Listen carefully to the machine before
unplugging it to make sure that all
mechanical noise has stopped. Not
allowing the machine to finish this parking
process may lead to print problems and
possible damage to the print head.
a
Unplug the machine from the telephone
wall jack and take the telephone line
cord out of the machine.
b
Unplug the machine from the AC power
outlet.
c
Using both hands, use the plastic tabs
on each side of the machine to lift the
scanner cover into the open position.
Then unplug the interface cable from the
machine, if it is connected.
d
Remove the orange protective part from
the inside right corner of the machine.
e
Gently close the scanner cover using
the plastic tabs on each side as you
push down on the Scanner Cover
Support (1).
WARNING
Be careful not to trap your fingers under the
scanner cover.
Always use the finger holds provided on
each side of the scanner cover when
opening and closing it.
f
Open the ink cartridge cover.
g
Press the ink release levers to release
the ink cartridges and then take out the
ink cartridges. (See Replacing the ink
cartridges in appendix A of the Basic
User’s Guide.)
1