Boss Audio Systems GT-100 - Manual (Page 27)

27
Q
uick G
uide
O
ver
vie
w
O
utputting S
ound
Eff
ec
ts
Sa
ving
Pedal S
ettings
Sy
st
em
MIDI/USB
A
ppendic
es
Creating Sounds (Effects)
Setting the Effects
Use the left and right displays and knobs [1]--[8] to edit the settings
of the internal effects.
Reference
For details on the basic procedures for manipulating effects,
refer to ”Editing: Editing the Effects” (p. 16).
Specifying the Divider and Mixer
Modes
Within the effect chain, the point where the signal is split into
channels “A” and “B” is called the “divider,” and the point where the
two signals are recombined is called the “mixer.”
You can use the divider to switch between channels “A” and “B,” to
assign strongly picked notes and softly picked notes to different
channels, or to assign different frequency bands of your guitar
sound to different channels.
The mixer lets you adjust the volume balance of channels “A” and “B,”
place them in the stereo field, or slightly delay the sound of channel
“B” to produce a spacious sound.
DIVIDER MIXER
Divider settings
1.
Press the [EFFECT] button .
2.
Use knob [4] to select “DIVIDER .”
3.
Use knobs [5]–[8] and the PAGE [ ][ ] buttons to make
settings .
Con-
troller Parameter
Value Explanation
Page 1
[5] MODE
SINGLE
Use only one channel, either
“A” or “B.”
DUAL
Use the two channels “A” and
“B.”
Single mode settings
If you selected “SINGLE” with knob [5]
Con-
troller Parameter
Value Explanation
Page 1
[6]
CH SELECT CH. A, CH. B Selects the channel to use.
Dual mode settings
If you selected “DUAL” with knob [5]
Con-
troller Parameter
Value Explanation
Page 2
[5]
CH . A
DYNAMIC
OFF DYNAMIC will not be used.
POLAR+
Only notes picked more
strongly than the DYNAMIC
SENS setting will be output.
POLAR-
Only notes picked more
softly than the DYNAMIC SENS
setting will be output.
[6]
CH . A
DYNAMIC
SENS
0–100
Specifies the picking
sensitivity.
[7] CH . A FILTER
OFF The filter will not be used.
LPF
Only the region below the
cutoff frequency will be
output.
HPF
Only the region above the
cutoff frequency will be
output.
[8]
CH . A CUTOFF
FREQ
100 Hz–2 kHz Cutoff frequency
Page 3
[5]
CH . B
DYNAMIC
OFF DYNAMIC will not be used.
POLAR+
Only notes picked more
strongly than the DYNAMIC
SENS setting will be output.
POLAR-
Only notes picked more
softly than the DYNAMIC SENS
setting will be output.
[6]
CH . B
DYNAMIC
SENS
0–100
Specifies the picking
sensitivity.
[7] CH . B FILTER
OFF The filter will not be used.
LPF
Only the region below the
cutoff frequency will be
output.
HPF
Only the region above the
cutoff frequency will be
output.
[8]
CH . B CUTOFF
FREQ
100 Hz–2 kHz Cutoff frequency