Barco GRAPHICS 500 R9002930 - Manual (Page 92)

9. Signal Menu
When the source switching mode is the fade in/out mode, the audio (when available) switching will also be
done using a fade in/out effect.
9.2 Background
Purpose
If there is no signal connected to the projector, the background will be a logo, a black or a blue screen depending on the background
settings.
How to change the background ?
1. Press MENU to activate the Toolbar
2. Press → to select the Signal item
3. Press ↓ to Pull down the Signal menu
4. Use ↑ or ↓ to select Background
5. Press → to pull down the menu
6. Use ↑ or ↓ to select the desired background (image 9-2)
7. Press ENTER
Image 9-2
The logo display is only possible in the full screen mode, a logo can thus not be displayed (rescaled) in a
window in the PiP mode.
When there is no signal connected, the projector will also start its standby timer countdown (if enabled) and
shuts down after the predetermined time.
88 R5976367 BARCOIQ GRAPHICS 500 01/02/2007