Barco GRAPHICS 500 R9002930 - Manual (Page 36)

4. Getting started
Image 4-1
Local keypad layout
Remote control functions.
This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the projector remotely. This
remote control is used for source selection, control, adaptation and set up. It includes automatic storing of picture controls (Bright-
ness, Sharpness...) and settings.
Other functions of the remote control are :
•
switching between stand by and operational mode.
• switching to "pause" (blanked picture, full power for immediate restarting)
• direct access to all connected sources.
Diagnose LED’s
Green Red
LED1 cool down sequence: flickers 60 seconds (120
seconds in case of iQ 400 series) after switching
to standby rescue program (software error)
LED2 only for the versions containing a server:
shows when projector is in
standby and server is active.
hardware error
LED3 IR acknowledgement continue : standby
flickers : Security = ON
32 R5976367 BARCOIQ GRAPHICS 500 01/02/2007