Broilmaster BRB-1 - Manual (Page 8)

Page 8 B101502-1-0311
BHa & BHaX a
sseMBly
Attention: If applicable, remove protective film from parts
before installation.
1. Remove the surround from the shipping box and place
the BHA surround into position in the constructed
enclosure. See Figure 1.
2. Secure the BHA surround to the enclosure using eight
(8) 8 x 3/4” Hex Head Screw screws. See Figure 2.
Note: If you have a masonry structure you may need to
substitute for the appropriate masonry fasteners.
3. Place the grease tray into BHA surround by sliding it
under the bracket. See Figure 3.
4. Place the control housing assembly into BHA surround
and secure it to the BHA surround. See Figure 4.
5. Attach the flex line to the bottom of the BHA surround
using the flex line bracket and screw. See Figure 5.
Figure 1
Figure 2
GREASE TRAY
BHA ASSEMBLY
Figure 3
BHA ASSEMBLY
CONTROL HOUSING
ASSEMBLY
Figure 4
Figure 5