Sharp LL-S201A - Manual (Page 2)

Summary of Changes .......................................................................................................... 4
1. Introduction .................................................................................................................. 5
1.1. TOOL OPERATING ENVIRONMENT ................................................................ 5
1.2. INSTALLATION PROCEDURES ........................................................................ 5
1.3. USE
INSTRUCTIONS .......................................................................................... 5
1.4. CONFIRMATION OF THE SERVICE TOOL VERSION ................................... 6
2. CONNECTION and LIMITATION .............................................................................. 7
2.1. CONNECTION ..................................................................................................... 7
2.2. LIMITATION
......................................................................................................... 7
2.3. USAGE AT MULTI DISPLAY .............................................................................. 7
3. COMPOSITION OF THE SERVICE TOOL SCREEN ............................................... 8
4. MAKE A CONNECTION BETWEEN LL-S201A AND PC ........................................ 9
5. QUICK SUMMRY OF THE FEATURE .................................................................... 11
5.1. Firmware version up (Version UP) ..................................................................... 11
5.2. Setting the destination of model (MODEL) ....................................................... 11
5.3. Changing the serial number (Serial Number) ................................................... 11
5.4. Setting the LED back light usage time (Back Light Usage Time） ................. 11
5.5. Backup and restore the White Balance settings (White Balance Settings) ..... 11
5.6. Factory
reset (Factory Reset) ............................................................................. 11
5.7. Start aging（Aging） .......................................................................................... 11
5.8. Power LED lighting test (Power LED Test) ....................................................... 11
5.9. Display Test pattern (Test Pattern) ................................................................... 11
5.10.
Touch panel adjustment (TC Adjustment) ..................................................... 11
6. FIRMWAER VERSION UP（Version UP） .............................................................. 12
6.1. Overview .............................................................................................................. 12
6.2. Storing position of version up data .................................................................... 12
6.3. Scalor
part version up ......................................................................................... 13
6.3.1. Notes during the upgrade ............................................................................... 15
6.3.2. Tips ................................................................................................................... 15
6.4. Touch part version up ......................................................................................... 16
6.4.1. Note during upgrade ....................................................................................... 17
6.5. Simultaneous Upgrade (Scaler Part + Touch Part) ........................................... 18
6.6. NOTES AND LIMITATION ................................................................................ 18
6.6.1. Scaler part version up ..................................................................................... 18
6.6.2. Touch part version up ...................................................................................... 18
7. SETTING THE DESTINATION (MODEL) .............................................................. 19