Sharp UP-600 - Manual (Page 29)

28
3. Creating/updating the master list — master
(1) Creating the master list
This may only be performed on the pre-designated master.
1.
Turn the mode switch to the PGM2 position.
2.
Select “INLINE SETTING” and press the [ENTER]
key.
The INLINE SETTING menu will open.
3.
Enter a terminal number for IP ADDRESS 4 from (0 -
254) for the master and then carry out the
programming for other INLINE SETTING items and
press the [ENTER] key. The window for the creation of
the master list will open.
4.
Enter the terminal number (1 - 254) for the master in
the IRC system and press the [ENTER] key. The
machine number line will appear.
5.
Enter the machine number (1 - 999999) that
corresponds to the master’s entered terminal number
and press the [ENTER] key.
6.
Repeat steps 4 to 5 for all satellites in the IRC system.
Press the [CA/AT] key to complete the master list.
(When the back-up master is enabled, the “BMA
MACHINE” line will appear to enter the machine
number (see page 31 ). To return to the PGM2 mode
menu, press the [CANCEL] key.