Sharp XE-A137-BK - Manual (Page 73)

71
EURO MIGRATION FUNCTION
NOTE
EURO programming described in this section are for users in the countries which will join to the
members of the European Currency Union, not for the users in the countries already have joined the
Union.
Your register can be modified to correspond with each period set for the introduction of EURO, and in your
register each currency is treated as shown on the table below depending on which period you are in.
Basically your register can be automatically modified to correspond to the introduction of EURO by executing
automatic EURO modification operation shown below in the Z/PGM mode. However, there are several options
you must set depending on your needs. So, please carefully conduct necessary settings.
How currencies are treated in your register
Period 1 Period 2 Period 3
After the introduction of
EURO, and before EURO
banknotes and coins begin
to circulate After EURO banknotes
and coins begin to
circulate, and before
national currency is
withdrawn from circulation.
(Co-existence of EURO
and national currency) After the national currency
is withdrawn from
circulation
Currency
EURO Exchange key Domestic currency Domestic currency
National currency Domestic currency Exchange key
Foreign currency Exchange key
Automatic EURO modification operation
Make sure the mode switch is in the Z/PGM mode first, then perform the following procedure. Please note that
you can perform each operation only once with the substitution of “A=1”, “A=2” and “A=3”. For example if you
performed the operation with the substitution of “A=2” first, you cannot perform the operation with the
substitution of “A=1”.
A @ *A 800
* A=1: Applicable for period 1
* A=2: Applicable for period 2
* A=3: Applicable for period 3