Sharp XE-A137-BK - Manual (Page 70)

68
READING (X) AND RESETTING (Z)
OF SALES TOTALS
• Use the reading function (X) when you need to take a reading of sales information entered since the last reset.
You can take this reading any number of times. It does not affect the register’s memory.
• Use the resetting function (Z) when you need to clear the register’s memory. Resetting prints all sales
information and clears the entire memory except for the GT1 through GT3, reset count, and consecutive
number.
1 Summary of Reading (X) and Resetting (Z) Reports
X1 and Z1 reports: Daily sales reports
X2 and Z2 reports: Periodic (monthly) consolidation reports
When you take an X1 or X2 report, turn the mode switch to the X/Flash position, and use the corresponding key
sequence.
When you take an Z1 or Z2 report, turn the mode switch to the Z/PGM position, and use the corresponding key
sequence.
Item
Mode switch position
Key operation
X/Flash Z/PGM
Full sales report
Daily report (X1/Z1) X1 Z1 A
Periodic report (X2/Z2) X2 Z2 H A
PLU report
X1 Z1
p
For all PLUs
End PLU
code
For a start PLU
Start PLU
code
@
Hourly report X1 Z1 v
Flash report (only display) To clear the display, press the l key or turn the
mode switch to another position.
Department sales total X1 ―
For dept.1 to dept.4: ! to $
For dept.5 to dept.8: H ! to H $
Cash in drawer total X1 ― c
Sales total X1 ― C
NOTE
• When both sales quantities and sales amounts are zero, printing is skipped. If you do not want to skip,
change the programming. (Refer to “Print format” of “Various Function Selection Programming 1” on
page 53.)
• “X” represents read symbol and “Z” represents reset symbol in the reports.
• To stop reading and resetting the PLU sales report, press the E key.
The data will not be erased when you reset.
• The drawer does not open when you take X/Z reports.
The drawer can be opened by pressing the A key in REG mode to remove it after closing your
business.