BenQ DLP PROJECTOR PE8700 - Manual (Page 3)

2
1.
Safety Precautions
1. Be sure to read this manual before servicing and save it for future reference.
2. The lamp becomes extremely hot during operation. Allow the projector to cool for
approximately 45 minutes prior to removing the lamp assembly for replacement. Do not
operate lamps beyond the rated lamp life. Excessive operation of lamps beyond the
rated life could cause them to explode on rare occasions.
3. Never replace the lamp assembly or any electronic components unless the projector is
unplugged.
4. To reduce the risk of electric shock, do not disassemble this appliance. Take it to a
qualified technician when service or repair is required. Incorrect re-assembly can cause
electric shock when the appliance is subsequently used.
5. Do not place this product on an unstable cart, stand, or table. The product may fail,
sustaining serious damage.
2. Servicing Precautions
1. When replace the lamp, be sure to avoid burns your fingers because the lamp becomes
too hot.
2. Never touch the lamp bulb with a finger or anything else. Never drop it or give it a shock.
They may cause bursting of the bulb.
3. This projector is provided with a high voltage circuit for the lamp. Do not touch the
electric parts of power unit when turn on the projector.
4. Do not touch the exhaust fan during operation.