BenQ DLP PROJECTOR PE8700 User Manual
Page 20
19
2.12 Red Ramp test screen
This screen is used to test light border blemishes and bright pixels. All areas of the active
area are colored at a specific gray level, based on MS Paint 0-255 RGB scale:
Major Dark Blemish
Blue Value
0
Red Value
Start 0,end 255
Green Value
0
3. ACCEPTANCE REQUIREMENTS
3.1 Test Conditions (as tested in OEM projector)
· Projector degamma correction shall be linear. Using HD Control “Curtain” Mode is
equivalent.
· Image noise reduction algorithms “Blue Noise STM” and “Boundary Dispersion” shall be
set to “off”.
· Projector shall be used in front projection mode using a customer-specified screen, and
OEM optical system.
· The diagonal size of the projected image shall be 52 inches (132cm).
· The projected image shall be inspected from a 60 inches (1.52 meter) minimum viewing
distance.
· Projector will be properly focused on the DMD array as shown on the screen.
· Testing time is limited to 20seconds per screen.
· Refer to Table 1 for acceptance criteria, in specified order:
TEST
ORDER
TEST SCREEN
ACCEPTANCE
CRITERIA
1
Major Dark Blemish
Blue 90
No dark blemishes visible on Blue 90
2 Dark
Pixel
Blue 90
Zoned Screen (see
below figure 1)
0 dark pixels allowed in Zone A
<=2 dark pixels allowed in Zone B
No adjacent dark pixels
3 Border
Defects
Gray 10
No border defects visible
4
Major Light Blemish Gray 6
No light blemishes visible on Gray 6