Nokia N78 - Manual (Page 153)

● Network type — Select the internet protocol type
to transfer data to and from your device. The other
settings depend on the selected network type.
● Phone IP address (for IPv4 only) — Enter the IP
address of your device.
● DNS addresses — Enter the IP addresses of the
primary and secondary DNS servers, if required by
your service provider. To obtain these addresses,
contact your internet service provider.
● Proxy server address — Enter the address of the
proxy server.
● Proxy port number — Enter the port number of
the proxy server.
WLAN internet access points
Press , and select Tools > Settings >
Connection > Destinations > New access point ,
and follow the instructions on the screen. Or, open one
of the access point groups, select an access point
marked with , and select Edit .
Follow the instructions from your WLAN service
provider.
● WLAN network name — Select Enter manually or
Search for networks . If you select an existing
network, WLAN network mode and WLAN
security mode are determined by the settings of its
access point device.
● Network status — Define whether the network
name is displayed.
● WLAN network mode — Select Ad-hoc to create
an ad hoc network and to allow devices to send and
receive data directly; a WLAN access point device is
not needed. In an ad hoc network, all devices must
use the same WLAN network name .
● WLAN security mode — Select the encryption
used: WEP , 802.1x (not for ad hoc networks), or
WPA/WPA2 . If you select Open network , no
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network supports
them.
To enter the settings for the selected security mode,
select WLAN security settings .
Security settings for WEP
● WEP key in use — Select the wired equivalent
privacy (WEP) key number. You can create up to four
WEP keys. The same settings must be entered on the
WLAN access point device.
● Authentication type — Select Open or Shared for
the authentication type between your device and
the WLAN access point device.
● WEP key settings — Enter WEP encryption (length
of the key), WEP key format ( ASCII or
Hexadecimal ), and WEP key (the WEP key data in
the selected format).
Security settings for 802.1x and WPA/WPA2
● WPA/WPA2 — Select the means of authentication:
EAP to use an extensible authentication protocol
153
Se
ttings