Toshiba Pocket PC e750 - Manual (Page 160)

Additional Information
User's Manual 11-3
TOSHIBA Pocket PC e750 Version
1
Last Saved on 17/02/2003 14:46
ENGLISH using Euro_C.dot –– Printed on 17/02/2003 as e750
Symptom Cause Correction
Following message is
displayed:
“Not Enough Battery
Power. USB devices
can not be used.
Because PDA's battery
power is low.” The Battery power is too
low to use USB devices. Charge the battery or connect
AC adapter.
Following message is
displayed:
"TOO MUCH USB
CONNECTION "
"Connecting USB
devices are too much." The total power
consumption of
connected USB devices is
too large. This USB port supports total
500mA USB device. Confirm
connected USB device.
Following message is
displayed:
“USB OVER CURRENT
DETECT USB device is
turned off. Please
disconnect USB
device.” The total power
consumption of
connected USB devices is
too large. This USB port supports total
500mA USB device. Confirm
connected USB device.
To enable USB port again, turn
off the power of Pocket PC and
push Reset Switch.
Symptom Solutions
Cannot connect to the
network
■ Make sure the Wireless Communication Switch is
turned on.
■ Check if the SSID is correct (note that it is case-
sensitive)
■ Check Link Quality in Configuration Page. If the link
quality is poor, rescan and find another Access Point.
■ Check if the operating mode is set properly. See
Chapter 4, Configuration Page.
■ Check if the WEP key is correctly entered.
■ Be sure you are in the range of a working Access
Point.
■ Make sure the channel been set is in the range of
1~11.