Connect to work – Toshiba Pocket PC e750 User Manual
Page 104
Getting Connected
User's Manual
7-4
ENGLISH using Euro_C.dot –– Printed on 17/02/2003 as e750
To create an Ethernet connection to an ISP:
1
You do not need to create a new connection on your device. Instead,
you must purchase and configure an Ethernet card that is compatible
with your device.
2
Obtain the following information from your ISP: user name, password,
and domain name.
3
Insert the Ethernet card into your device. For instructions on inserting
and using the Ethernet card, see the owner’s manual for the card.
4
The first time you insert the card, Network Settings will appear
automatically so that you can configure the Ethernet card. Most
networks use DHCP, so you should not have to change these settings
unless your network administrator instructs you to do so. Tap OK. (If it
does not appear or to change settings later, tap
and then Settings.
In the Connections tab, tap Network Adapters, tap the adaptor you
want to change, and then tap Properties.)
5
Connect the Ethernet card to the network by using a network cable.
For information, see your owner's manual.
6
Tap
, Settings, Connections tab, and then Connections. From the
My network card connects
to list, select The Internet.
To start the connection, simply start using one of the programs listed in
the preceding section. Once connected, you can perform the same
activities as listed in the preceding section.
Connect to Work
If you have access to a network at work, you can send e-mail messages,
view intranet pages, synchronize your device, and possibly access the
Internet. You can connect to work in one of two ways:
■
Create a modem connection by using a RAS account. Before you can
create this modem connection, your network administrator will need
to set up a RAS account for you. If this is the method you want to use,
see “To create a modem connection to a network.” Your network
administrator may also give you VPN settings.
■
Use an Ethernet card and a net tap to connect to the network. If this is
the method you want to use, see “To create an Ethernet connection to
a network.”