Toshiba Portege R200 (PPR21) - Manual (Page 79)

User’s Manual 4-21
Operating Basics
Moving the computer
The computer is designed for rugged durability. However, a few simple
precautions taken when moving the computer will help ensure trouble-free
operation.
■ Before moving the computer, it recommends changing the function of
HDD Protection. Refer to the section, Using the Hard Disk Drive (HDD)
Protection , in this chapter.
■ Make sure all disk activity has ended before moving the computer.
Check the HDD indicator on the computer.
■ Turn off the power to the computer.
■ Disconnect the AC adaptor and all peripherals before moving the
computer.
■ Close the LCD display panel. Do not pick up the computer by its panel.
■ Before carrying your PC, shut down the PC, disconnect the power cable
and wait until the PC cools down. Failure to follow this instruction could
result in minor injury.
■ Always turn off the power when you move the PC. If the power button
has a lock, set it to the lock position. Also be careful not to subject the
PC to impact. Failure to follow this instruction could result in damage to
PC, PC failure or loss of data.
■ Never transport your PC with PC cards installed. This could cause
damage to your PC and/or PC card, resulting in product failure.
■ Use the carrying case when transporting the computer.
■ When carrying your computer, be sure to hold it securely so that it does
not fall or hit anything.
■ Do not carry your computer by holding protruded portions.
Using the Hard Disk Drive (HDD) Protection
There is a function for reducing the risk of damage on HDD in this
computer.
Using the acceleration sensor built in the computer, HDD Protection detects
vibration, shocks and similar signs in the computer, and automatically
moves the HDD head to a safe position in order to reduce the risk of
damage that could be caused by a head-to-disk contact.
When vibration is detected, the following message is displayed, and the
icon in the notification area of the taskbar is changed to the protection
state. This message is displayed until the OK button is pressed or
30 seconds pass. When vibration subsides, the icon returns to the
normal state.
This function does not guarantee that the HDD will not be damaged.