Toshiba Portege R200 (PPR21) - Manual (Page 63)

User’s Manual 4-5
Operating Basics
Set Up Procedure
Please use the following procedure when first using fingerprint
authentication.
Fingerprint Registration
Enroll the required authentication data using the "OmniPass Enrollment
Wizard".
1. Click start, Point to All Programs, point to Softex and click OmniPass
Enrollment Wizard.
2. Click Enroll.
3. The Verify Username and Password screen is displayed. Ensure the
same Windows logon username and domain (*) before entering
password into the Password field. Click Next.
(*) If the Windows logon account is for use within a LAN domain, enter the
domain name. If you are unsure, please check with the network
administrator. If not used within the LAN domain, just enter the computer
name.
4. The Choose Finger screen is displayed. Based on the illustration,
select the finger to be recognized, and then click Next. Previously
enrolled fingerprints would have green check marks. The fingerprint
being enrolled now would have a red check mark. If any of the
previously enrolled fingerprints is selected again, the latest information
will be enrolled and previous information over-written.
We recommend first-timers to click Practice, and then swipe the finger as a
practice.
5. The Capture Fingerprint screen is displayed. Follow the onscreen
instructions and use the same finger you have selected under Choose
Finger to swipe three times to allow the sensor to read the fingerprint.
The fingerprint will be shown in green if properly read, or in red if the
reading is abnormal.
6. The Verify Fingerprint screen is displayed. Swipe the finger again to
allow the sensor to read again. When the Verification Successful
message is displayed, click Next.
In case of finger injury or authentication failure, it is recommended that
another fingerprint also be enrolled. The following message will be
displayed:
"It is recommended that you enroll at least two fingers. Would you like
to enroll an additional finger now?"
Click Yes and repeat steps 3, 4, 5 with another finger.
7. The Audio and Taskbar Settings screen is displayed. Click Next.
The Congratulations screen is displayed. Click Done.
The fingerprint authentication uses the same Windows logon ID and
password. If the Windows logon password has not been setup, please do
so before registration.