Toshiba Tecra S4 - Manual (Page 135)

User’s Manual 7-7
HW Setup & BIOS Setup
Built-in LAN
This feature enables or disables the Built-in LAN.
Device Config
Device Configuration
This option allows you to set how the computer’s hardware devices will be
configured.
Parallel/Printer
Some models are equipped with Parallel/Printer tab. This tab lets you set
the Parallel Port Mode. Use the Windows Device Manager to make settings
for the Parallel port.
Parallel Port Mode
The options in this tab are ECP and Standard Bi-directional.
USB
USB KB/Mouse Legacy Emulation
You can use this option to enable or disable USB keyboard/mouse legacy
emulation so that, even if your operating system does not support USB
devices, you can still use a standard USB mouse and keyboard - to achieve
this you should set the appropriate option(s) to Enabled.
Do not install or remove an optional memory module while Wake-up on
LAN is enabled.
The Wake-up on LAN function consumes power even when the system is
off. Leave the AC adaptor connected while using this feature.
Enabled Enables Built-in LAN functions (Default).
Disabled Disables Built-in LAN functions.
All Devices The computer’s BIOS will setup and configure all
devices.
Setup by OS The operating system will setup and configure all
of the devices that it can control (default).
ECP Sets the port type to Extended Capabilities Port
(ECP). For most printers, the port should be set
to ECP (Default).
Standard
Bi-directional This setting should be used with some other
parallel devices.