Restoring the pre-installed software, Creating optical recovery discs – Toshiba Portege A600 User Manual
Page 30
User’s Manual
1-13
Getting Started
Restoring the pre-installed Software
Depending on the model you purchased, different ways for restoring the
pre-installed software are offered:
■
Creating optical Recovery Discs
■
Restoring the pre-installed software from your created Recovery Discs.
■
Restoring the pre-installed software from the Recovery hard disk drive
Creating Optical Recovery Discs
This section describes how to create Recovery Discs.
A recovery image of the software on your computer is stored on the hard
disk drive, and can be copied to DVD media by using the following steps:
1. Have blank DVD media ready.
2. The application will allow you to choose from a variety of different media
onto which the recovery image can be copied including DVD-R,
DVD-RW, DVD+R, DVD+RW.
3. Turn on your computer and allow it to load the Windows Vista
®
operating system from the hard disk drive as normal.
4. Insert the first blank media into the optical disc drive tray.
5. Double click the Recovery Disc Creator icon on the Windows Vista
®
desktop, or select the application from Start Menu.
■
Be sure to connect the AC adaptor when you create Recovery Discs.
■
Be sure to close all other software programs except the Recovery Disc
Creator.
■
Do not run software such as screen savers which can put a heavy load
on the CPU.
■
Operate the computer at full power.
■
Do not use power-saving features.
■
Do not write to the disc when the virus check software is running. Wait
for it to finish, then disable virus detection programs including any
software that checks files automatically in the background.
■
Do not use utilities, including those intended to enhance hard disk
drive access speed. They may cause unstable operation and damage
data.
■
Do not shut down/log off or Sleep/Hibernate while writing or rewriting
the disc.
■
Set the computer on a level surface and avoid places subjected to
vibrations such as airplanes, trains or cars.
■
Do not place your computer on unstable tables or any other unstable
surfaces.
Please note that some of the above media may not be compatible with the
optical disc drive installed into your computer. You should therefore verify
the optical disc drive supports the blank media you have chosen before
proceeding.