Toshiba PORTEGE R700 User Manual
Page 72
8.
Seat the memory module cover in place and secure it with the screws.
Take care to ensure that the memory module cover is firmly closed.
Figure3-10Seating the memory module cover
1
2
1.
Memory module cover
2.
Screws
9.
Install the battery pack - refer to
chapter 6, Power and Power-Up Modes, if required.
10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized
- to confirmed it, click Start > Control Panel > System and Security
> System.
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1.
Shut down the computer - make sure the Power indicator is off (refer
to the
section in chapter 1, Getting Started if
required).
2.
Remove the AC adaptor and all cables and peripherals connected to
the computer.
3.
Close the display panel.
4.
Turn the computer upside down and remove the battery pack (refer to
section in chapter 6, Power and Power-Up
Modes, if required).
5.
Loosen the screws securing the memory module cover in place -
please note that the screws are attached to the cover in order to
prevent them from being lost.
6.
Slide your fingernail or a thin object under the cover and lift it off.
7.
Push the latches away from the module in order to release it - a spring
will force one end of the module up at an angle.
PORTÉGÉ R700 / Satellite R630
User's Manual
3-27