Toshiba SATELLITE L300 - Manual (Page 132)

User’s Manual 9-12
Troubleshooting
Sleep/Hibernation
LAN
After making a call
you can’t hear a ring Make sure the tone or pulse selection in your
communications application is set correctly.
You can also use the ATD command.
Communication is cut
off unexpectedly The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.
A CONNECT display is
quickly replaced by
NO CARRIER Check the error control setting in your
communications application.
You can also use the AT\N command.
Character display
becomes garbled
during a
communication In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
You cannot receive an
incoming call Check the rings before auto answer setting in an
incoming call your communications application.
You can also use the ATS0 command.
If problems persist, contact your dealer.
Problem Procedure
Problem Procedure
The system will not
enter
sleep/hibernation Is Windows Media Player open? The system
might not enter sleep/hibernation, if Windows
Media Player is either playing a selection or
finished playing a selection. Close Windows
Media Player before you select
sleep/hibernation.
If problems persist, contact your dealer.
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN Make sure the AC adapter is connected. The
does not work Wake-up on LAN function
consumes power
even when the system is off.
If problems persist, consult your LAN
administrator.