Switching auto pi seek 46, Switching the warning tone 46, Switching the auxiliary setting 46 – Pioneer FH-P4100R User Manual

Page 46: Switching the dimmer setting 46, Switching the rear output setting 46, Switching auto pi seek, Switching the warning tone, Switching the auxiliary setting, Switching the dimmer setting, Switching the rear output setting

Black plate (46,1)

CRD3576-A

Switching Auto PI Seek

The unit can automatically search for a differ-

ent station with the same programming, even

during preset recall.

1 Press FUNCTION to select A-PI.

Press FUNCTION repeatedly until A-PI ap-

pears in the display.

2 Select A-PI on or off with a/b.

Pressing a/b will switch A-PI between on and

off and that status will be displayed (e.g.,

A-PI :ON).

Switching the warning

tone

If the front panel is not detached from the

head unit within five seconds of turning off the

ignition, a warning tone will sound. You can

turn off this warning tone.

1 Press FUNCTION to select WARN.

Press FUNCTION repeatedly until WARN ap-

pears in the display.

2 Select WARN on or off with a/b.

Pressing a/b will switch WARN between on

and off and that status will be displayed (e.g.,

WARN :ON).

Switching the auxiliary

setting

It is possible to use auxiliary equipment with

this unit. Activate the auxiliary setting when

using auxiliary equipment connected to this

unit.

1 Press FUNCTION to select AUX.

Press FUNCTION repeatedly until AUX ap-

pears in the display.

2 Select AUX on or off with a/b.

Pressing a/b will switch AUX between on

and off and that status will be displayed (e.g.,

AUX :ON).

Switching the dimmer

setting

To prevent the display from being too bright at

night, the display is automatically dimmed

when the cars headlights are turned on. You

can switch dimmer on or off.

1 Press FUNCTION to select DIMMER.

Press FUNCTION repeatedly until DIMMER

appears in the display.

2 Select DIMMER on or off with a/b.

Pressing a/b will switch DIMMER between

on and off and that status will be displayed

(e.g., DIMMER :ON).

Switching the rear output

setting

This units rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker or subwoofer connection. If you

switch the rear output setting to the subwoo-

fer, you can connect a rear speaker lead di-

rectly to a subwoofer without using an

auxiliary amp.

! If you connect a subwoofer to the rear out-

put, set the output setting to subwoofer.

Initial Settings

Section