Adjusting bbe sound level 43, Using the position selector 43, Using the position selector – Pioneer FH-P4100R User Manual
Page 43: Digital signal processor 10, Adjusting bbe sound level
Black plate (43,1)
43
CRD3576-A
# If the sound field control has been previously
set to a sound field program then the title of that
previously selected sound field program will be
displayed, such as STUDIO, JAZZ, CLUB, OCT1,
OCT2, or BBE.
2 Select a sound field program by
pressing 16.
Select the desired sound field program by
pressing one of the numbered buttons, from
16, which correspond to the different sound
field programs as listed above.
# You can also sequentially select a sound field
program by pressing c or d.
Adjusting BBE sound level
With BBE sound processing technology, you
can adjust the level of BBE.
1 Recall BBE.
See Recalling sound field programs on the pre-
vious page.
2 Press a or b to adjust the level of
BBE.
Each press of a or b increases or decreases
the level of BBE.
+4 4 is displayed as the level is increased
or decreased.
Using the position selector
One way to assure a more natural sound is to
clearly position the stereo image, putting you
right in the center of the sound field. The posi-
tion selector adjusts the volume level of sound
from each speaker to match seat positions
and the number of people in the car and lets
you recall settings at the touch of a button.
Here is a list of the positions:
Button Display
Indicator
Position
a
FRONT
Front seat
b
ALL
All seats
c
FRONT-L
Front seat left
d
FRONT-R
Front seat right
1 Press DSP to select the position
selector.
Press DSP until POSI appears in the display.
# If the position selector has been previously
set to a listening position then the title of that pre-
viously selected listening position will be dis-
played, such as FRONT, ALL, FRONT-L or
FRONT-R.
2 Press c/d/a/b to select a listening
position.
Press one of these, c/d/a/b, to select a lis-
tening position as listed in the table.
# To cancel the selected listening position,
press the same button again.
# When the rear output setting is subwoofer,
you cannot select ALL. Refer to Switching the rear
output setting on page 46.
Digital Signal Processor
10
En
43
English
Section