Calibration 26, Setting the navigation, Calibration – Pioneer ANH-P10MP User Manual

Page 27

Setting the Navigation

Calibration

After commissioning , a calibration journey is
required. During the journey, the speedometer
signal is adapted to the vehicle-specific data
and the gyro sensors are adapted to the installa-
tion position of the unit.
The distance to be covered depends on the type
of vehicle and the local conditions.

Note

• The navigation system is only ready for opera-

tion on completion of the calibration journey.
The main navigation menu is displayed. Final
precision is only achieved after a further jour-
ney (calibration status 3).

In service garage mode, select

CALIBRA-

TION RIDE

using the rotary stick and press to

confirm.

The calibration status (e.g.

STATUS: 2

) and the

type of locationing (e.g.

) are displayed. After

completing calibration, the street in which you
are currently driving is displayed (provided that
it is digitised) instead of

WHEEL

and

REVERSE

Deleting the calibration

If the navigation system is removed from one
vehicle and installed in another vehicle, it must
be calibrated. However, to do so, the current
calibration data must be deleted.

In service garage mode, select

CALIBRATION

using the rotary stick and

press to confirm.

Using the rotary stick, select

DELETE

and

press to confirm.
The calibration is deleted and the unit returns to
service garage mode.

Calibration setting

Note

• Calibration settings should only be made

when the values to be entered are known. The
unit cannot make correct route calculations if
incorrect values are entered.

In service garage mode, select

CALIBRATION

using the rotary stick and

press to confirm.

English

Espa

Deutsch

Fran

ais

Italiano

Nederlands

CRD3863A_inst_002-029_UK 4/9/04 2:05 PM Page 27