Pioneer ANH-P9R - Manual (Page 19)

(
(
1
*
/,6+
1DYLJDWLRQ
9ryr‡vtƇ‚ rqÃqr†‡vh‡v‚†
Select destination memory (see page 25).
9r†‡vh‡v‚Ã€r€‚ ’Ãsˆyy
5RXWH JXLGDQFH FDOFXODWLRQ
After the first route guidance announcement, the prompt flashes on the display until
the route has been completely calculated. When entering a destination, driving off
should be delayed until no longer flashes.
Srphypˆyh‡vtÇurà ‚ˆ‡r
Select the destination to be deleted
using the rotary stick and press the
multifunction button.
Occurs when the destination memory is
full.
Select either “DELETE” (to jump to the
destination memory in order to delete a
destination) or “BACK” (to cancel
saving).
The message “Calculating route”
indicates that the distance is being
calculated, which may take several
seconds.
If the current route is not followed due to
road blocks, diversions, unintentional
driving in the wrong direction or failing to
observe the recommendations, the
system immediately calculates a new
route. During this recalculation, “NEW
ROUTE” is displayed.
6WRSRYHU
This function enables a stopover to be entered when route guidance is active.
@‡r vtÃhƇ‚ƒ‚‰r
‡ 9@TUÃH@HPS`
(see page 25) Select the stopover from the destination memory.
‡ 9@TUDI6UDPI
(see page 14) allows entry of a stopover with the precise specification of the address.
‡ QPD
(see page 25) enables the selection of special destinations as stopovers via “LOCAL
AREA”, “NEAR DESTINATION” and “TOWN/COUNTRY”, e.g. petrol stations or
airports.
T‡h ‡vtà ‚ˆ‡rÃphypˆyh‡v‚Ã‡‚ÃhƇ‚ƒ‚‰r
I‚‡r
‡ The symbol is displayed inversely during route guidance to a stopover.
Press the multifunction button .
Using the rotary stick, make a selection
and press to confirm.
To start route calculation to the
stopover, press the
I6WDPF button.
The route is calculated and route
guidance begins.
MAN-ANH-P9R-GB.fm Page 19 Tuesday, June 4, 2002 1:39 PM